RT6-a Series - 5.8GHz Microwave Motion Sensor | For Norani, Durado, Tucana & Rotate Series, Remote Programmable

Rugged Grade RT6-A Series Motion Sensor Add-On for Durado 3+, Rotate 4+, Norani Series and Tucana 2+ Series Wall Packs - Premium Microwave 5.8ghz Sensor - 1/2" Conduit Knuckle Mount - Fits 80 Watt and Higher Tucana II Series and Durado Series LED Wall Pack Lights - Step Dimming and Daylight Sensor Built-in - Easy Install - Optional Remote for Programming. (see Fitment below)

Motion Sensor Remote Spec Sheet: Motion Sensor Remote Control Instructions and Spec Sheet

Motion Sensor Specific Spec Sheet: Motion Sensor Spec Sheet

Fitment

Fits Durado 3 80w and 120w Durado 4 Series All

Fits Tucana 2 80w and 120w. Tucana 3 Series Uses 79-137 version of this sensor.

Fits Rotate 3 40w only. Rotate 4 Series All

Fits Stelora 1 Series All

Fits Norani 1 series but requires a 79-107 to be purchased and installed as well

(All require wiring. Not a twist in. May lose wattage select and or dimming after install)

ADD MOTION TO WALL PACKS - Convert any 80 watt or higher Tucana II Series , Durado III Series Wall pack, Rotate 3 40w, Rotate 4 All, Durado 4 all and more.

PREMIUM SENSOR - 5.8Ghz RT6-A Series Microwave sensor is dramatically more accurate than infrared PIR sensors. Up to 65 ft range of motion sensing ability.

STEP DIMMING - Set brightness setting for with motion and separate brightness for optional standby period before the light turns off with no motion detected. Standby period can be set to infinite so the light will always be on at a dim setting and go brighter when motion is detected.

DAYLIGHT SENSOR BUILT-IN - Adjustable daylight sensor built-in for dusk to dawn operation. Save money and your time by having a light that automatically turns on when it gets dark and turns back off when it gets light. Can be disabled if not desired.

OPTIONAL REMOTE - Add the optional remote (part# 79-143) to easily program the motion sensor options. This allows adjusting the brightness and time the light stays on with motion and the following standby period along with other functions like the daylight sensor and sensitivity. One remote can program every sensor so only 1 remote is needed at a location. Default sensor settings are 70% Brightness with Motion for 10 seconds and 10% Brightness at all other times, 20% Sensitivity and the Daylight Sensor disabled.

EASY INSTALL - Extremely easy install. Uses a 1/2" threaded connection. Designed to thread into a standard conduit entrance. Easy 3 wire connection.

QUALITY AND WARRANTY - High Quality Design has an IP65 Waterproof rating when installed in fixture. Unit is backed by our 5 Year Warranty.